Water Heater Troubleshooting And How To Repair
Water heater is one of the most important things in one’s household. However, it is not always possible to maintain water heater and its additional parts with a monthly plumbing company. Maintaining and fixing a water heater is relatively easy.
Once you have learnt the tricks, you can successfully carry out the tedious chore by yourself. However, if you have a leakage in the tank in the water heater, nothing can be done. You have to replace it. For all the other major concerns, just read the article and master the art of fixing it.
Knowing the device
You need to know the device and its parts, in order to understand its functioning. Typically a heater will have large water holding tank, which will usually 30 to 60 gallon water capacity. It will have a cold water opening for in taking the water. A dip tube will be placed right in the junction and it will transport the cold water to the bottom of the tank.
Lastly, it will have sacrificial rod, which ensures the safety of your tank from corrosion and erosion. Now, the dip tube is the part which electrically heats the water and converts it into hot water.
How to detect the problem
Start with draining out the hot water heater
First and foremost you need to test, which part is not working properly. For this reason, you need to make the tank empty as you cannot understand it from the surface. Turn of the electric panel. Close the cold water intake, give it some time for the hot water to cool down inside.
Lastly, open the hot water outlet and let the water drain away. It is best if you can perform the task, somewhere in a dry area. it is advised that to drain the water into a basin. This is because sometimes a small amount of hot water may remain small. It is better to be careful.
Get rid of the sediment
Most of the time, the natural cold water that is coming in will have small particles in it. These small particles accumulate and get settled at the bottom of tank, forming sediment. Most people have reported a smell of rotten egg around the tank with an unpleasant gurgling sound.
This happens because, the sediment is also getting heated up along with the water. At times, you may also notice water overflow, this may also happen because of sedimentation.
Now, once you have emptied your tank, fill up half of the tank, to get rid if the sediment. Flush the water out. Repeat the steps until the sediment is gone. To get rid of stubborn sediment, you can also use a water softner.
However, if you see that you are unable to get rid of it all. Then it is time to change the anodes of your system. You need to call the plumber and get a new anode installed.
You will not notice any time of sedimentation in a good quality water heater at it comes with a pre-installed water filter. Usually, these are costly but you can look for affordable water heaters San Diego in any online store. Just consult with a professional, before buying one.